
Sartre: ‘Adjusting the Length of Long Boots’
Sartre: ‘Adjusting the Length of Long Boots’
21 September 2022
- CATEGORY
- LADIES REPAIR
- SARTORE
Union Works is closed today, Wednesday.
Please be careful.
Did you know that, amongst shoe enthusiasts, there is occasionally a debate raging over ready-made versus bespoke shoes?
Shoes made to measure to fit your feet are the best!
No, no—they’re made to fit the shape of your feet, so the silhouette isn’t great. The ready-made ones look much better!
I can really see the point of both views.
When taking an order, we engage in repeated dialogue with the craftsman and take our time to create the piece together.
A story unfolds with every step.
If you discuss the silhouette, they’ll be fairly flexible about it, and you’ll inevitably grow quite attached to it.
With ready-made shoes, if you find a design you like, you can buy them at a lower price than made-to-measure ones, and you can start wearing them straight away.
Being the impatient sort that I am, whilst thinking I’d order one eventually,
I tend to buy ready-made ones because I just can’t wait to wear them as soon as I’ve bought them...
The reason I brought this up right at the start is that,
This is because a customer who visited our shop the other day made a request like this.

Customers bringing in Sartre long boots.
‘I really like the design, but when I sit down, the tube presses against my legs and it hurts.’
When I was shown how they looked when actually worn whilst sitting down,
The heel of the boot was pressing against the back of my knee.
‘Is there anything that can be done?’
‘I suppose bespoke is better than off-the-peg, isn’t it?’
Leave it to me.
One of its established strengths is the freedom it offers in terms of design.
There’s no point in buying a pair just because you like the design if you can’t actually wear them.
Following consultation with the customer,
This time, I decided to trim the shaft slightly to reduce the impact on the back of the knee.
The top line of these boots’ shafts is higher on the outside and lower on the inside.

It is characterised by the beautiful, smooth lines that connect them.

We’ll keep this beautiful silhouette as it is, whilst reducing the height of the cylinder.
This is the mission for this time.
First, mark out the line, then cut evenly all the way round.

After cutting, sand the top edge to make it even, so that it is easier to stitch.

Stitch all the way round just below the top edge, and

This is what it looks like once the thread has been treated.
The tube is quite long, so it was a bit of a struggle to sew it. I ended up sewing in a rather awkward position, so my shoulders are a bit stiff now, haha.

To finish off, sand the top line with a fine-grit file, apply the colour, and it’s complete.

I think we’ve managed to retain the beautiful lines, haven’t we?




Now you can wear your favourite designs without any hassle!
We look forward to welcoming you.
DM discount period now on!
Please do make the most of it!!
Thank you very much for staying with us until the end.
Aoyama Branch, Yokohama Branch, Yamada

