Sole replacement, stain removal and insole modification

Sole replacement, stain removal and insole modification

17 November 2022

We’ll be holding an event at our Aoyama branch on Sunday 20 November!

Please see this blog post for further details ↓

We are holding the 6th Shooholic Buy-Back & Pre-Order Fitting Event!

The DM discount is also valid until the 20th of this month.

Please do make use of it!

Notice Regarding the 2022 Summer Holidays and DM Special Offers

 

Here, we’ll be introducing some of our repair services.

Today, I’m repairing a pair of Church’s loafers.

As for what needs to be fixed,

First of all, the sole.

The pattern in the centre of the sole is starting to fade, and it has become considerably thinner, which is

You can tell just by looking.

The toe of the sole looks as though it’s about to reach the welt.

The top lift is also completely worn down.

It seems it would be better to replace the whole sole rather than just repairing parts of it.

 

Next, we will carry out stain removal.

Looking at the upper, it is mottled with white patches in places.

These white marks are caused by sweat (salt) and dirt that have accumulated inside the leather and risen to the surface.

This often occurs when the leather dries out after the upper has become wet, for example due to rain.

Wiping or polishing it will help a little, but,

As the rough texture remains or reappears on the surface almost immediately, this does not provide a permanent solution.

It is best to wash it thoroughly with water to remove all impurities from the leather.

This time, we’ll be removing stains as well.

 

Last but not least, the insoles.

In the case of shoes fitted with half-socks (insoles extending from the heel to around the waist),

As you can see in the photo, it often peels away and becomes curled up.

I find the feel of these on my feet quite bothersome, actually.

As I’ve got completely used to it,

If you simply stick it back on as it is, there’s a high chance it will come off again.

There are broadly two solutions to this.

One is to replace it with a full-length sock (covering the entire length from heel to toe).

Secondly, after cutting the section where the fabric has become creased, in order to reduce snagging,

Thin out the leather on the waist side.

As for the second one, there is a chance it might come off again, but,

It will be considerably reduced compared to the start.

This time, we’ll be customising the insoles using this method.

 

So, here is the finished result of the three items mentioned above

The sole has been finished with the same Dainite sole as the original.

I’ve cleaned the upper, so the leather has regained its original lustre.

The sock has also been carefully finished and glued in place.

It’s now much harder to peel off.

Dainite Soles

Cleaning

It feels great when you’ve fixed it properly, doesn’t it!

We look forward to welcoming you.

 

Aoyama Branch, Yokohama Branch, Yamada