
The item you’ve brought in today is a pair of Camper leather trainers.
It is one of the brands that continues to enjoy worldwide popularity amongst people of all ages and genders; originating in Spain, it is characterised by its distinctive rounded shape, unique designs and exceptional comfort.
The model you’ve brought in this time also has that distinctive sole that’s so typical of Camper…


The distinctive sole is worn down all over, and there is a hole in the centre.


The heel area has also been significantly worn away, with holes appearing just as in the centre, revealing the hollow space inside the sole.
Many people might simply choose to wear this sort of trainer-style shoe until it’s completely worn out…
As with these shoes, if there’s no major damage to the upper, it’s an even greater shame to wear them out completely, isn’t it…
However, whilst these shoes may look like trainers, they are actually designed so that the entire sole can be replaced!
So, I’ve had the soles completely replaced!


Unfortunately, we do not have the original soles in stock, so we used the rubber soles available from our company.
The colour is dark brown, as requested by the customer.
As the sole is in a similar shade of brown to the upper, the overall look is seamless and natural.

The original sole was simply glued on, but this time I sewed the sole in place using an insole.
By securely stitching the insole to the sole, you can prevent the sole from peeling away.

It’s hard to tell from the photograph, but if you take the shoes apart, you’ll see that with most Camper shoes, the sole is attached with a slight upward curve so that it wraps round the side of the upper.
Consequently, if you remove the original sole, traces of where it was glued will become visible on the sides of the upper that were originally covered by it.
So, rather than simply attaching the sole as it is…

I wrapped the decorative welt all the way round before attaching the sole.
By applying a decorative welt, we were able to neatly conceal the adhesive marks☆


The edge has also been finished to match the original, and

As the original sole was thinner at the front and thicker at the back, I finished the re-soling so that the rear half retains the same thickness as the original☆
As in this case, even with trainers, it may be possible to have the soles completely replaced, depending on their construction.
Unfortunately, we were unable to source the original soles, but we were able to achieve a finish as close to the original as possible.
‘I really like these shoes, but it doesn’t look like they can be repaired, so I suppose I’ll just have to wear them out as they are…’
I imagine quite a few of you are thinking that, aren’t you?
It may be possible to carry out a full sole replacement, or, if that isn’t possible, to carry out a partial repair.
Please do get in touch before you wear them out completely☆
We look forward to welcoming you all.
Thank you very much.
Shibuya Branch Shinjuku Branch Nakata
