Tricker’s CAP Country Boots
In this post, I’ll be showing you how we repaired these boots.

Although the last is the same 4497S as used for the MALTON and STOW models, these CAP Country Boots have no medallions or broguing, giving them a clean, understated look.
I think these shoes will go well with all sorts of trousers and will become a real go-to pair!
Actually, this photo was taken after the repairs had already been carried out – can you tell which parts have been retouched?
To be precise, it might be more accurate to describe it as a ‘change in specification’ rather than a repair.
Actually, this here...

「!?」
The original version of the photo shown earlier is a 10-eyelet boot that reaches down to around the shin, but in order to make it a 7-eyelet length,‘Shaft Cut’This was a photo taken after I’d done that.
The photo below shows the original length.

Cross-section

It’s a real treat to be able to see a cross-section of the finished upper!
You can see that, as one of the design features intended to help the shoes mould to the wearer’s feet, the lining and upper are not fully bonded but are instead secured with stitching.

I’ve also refitted the pull ring on the heel, so I think it looks seamless even when viewed from the side.

The length from the eyelet to the top, as well as the angle, have been faithfully reproduced.
If your boots are a length that’s difficult to match with trousers, why not try cutting the shaft?
Please note that, depending on the design of the boot, some shoes may not be suitable for this repair. This repair is subject to consultation, so we would appreciate your understanding.
At Union Works, we have boots similar to these‘Imitation Cap Country Boots’We stock these items.
I think this is the perfect pair for anyone who already owns a standard pair of country boots, or for those who aren’t keen on decorative details such as broguing, so please do take a look!

Tricker’s × UW Imitation Cap Country Boots ¥84,700
Thank you very much.
Ginza Branch Takiguchi
