
[Church’s] Church’s STANCE Toe Repair, Heel Replacement, Polishing
[Church’s] Church’s STANCE Toe Repair, Heel Replacement, Polishing
2 March 2024
- CATEGORY
- MEN'S REPAIR
- Church's

The ‘STANCE’ model from Church’s, one of the UK’s leading brands.
A pair of plain-toe shoes that, at first glance, look rather like the SHANNON model.
The upper is made of polished binder calfskin, which appears to be the same leather used in the Shannon and similar models.

If you look closely, you’ll see it has three eyelets and external grommets. With the Shannon model, there are five eyelets but no grommets. This alone makes a big difference to the overall look.

Looking at the lining, I can see that it uses a rather unusual last, known as the ‘43 last’.

Compared to the 103 last used in the Shannon, the toe appears slightly slimmer and the instep higher.

The insole design is also different. Whilst insoles are often only fitted in the heel area, this pair has an insole covering the entire sole, and with the addition of foam, it feels wonderfully soft and cushioned.
Let’s take a look at the sole.

A sole you don’t see very often.
As it turns out, these were actually golf shoes. We’ll be repairing them this time.

The sole pattern is still intact, so it appears to be fine, but as the rubber on the toe—which had been repaired previously—has come away, we will patch it up with rubber.


I’m also a little concerned about the wear on the top piece, and as I’ve been told it’s a bit slippery, I’ll be replacing this as well.
Here is the finished result


I’ve reattached the rubber toe cap. This time, I’ve re-sewn the outseam to ensure it doesn’t come away easily. With golf shoes, there’s a higher risk of the toe cap coming away when they get wet from morning dew and are subjected to movements such as swinging, so it’s better to have them stitched down for peace of mind.

We re-stitch the outseam, following the original stitching as closely as possible. As the welt is a vital component when replacing the sole in the future, we take care to minimise any strain on it.

As I do not have a top piece with the same pattern, I have replaced it with a Dainite heel that blends in with the sole’s pattern.
As we used a thicker component than the original top piece, we adjusted the stacking section to replace it whilst maintaining the same heel height.

Finally, I finished off by caring for the uppers. Removing the dirt and applying cream brought out a shine, which really changed their appearance.
Although the sole was a bit unusual this time, we were able to repair it without any problems.
If you have any concerns, such as ‘Can these shoes be repaired?’, please do not hesitate to contact us.
We look forward to welcoming you to our shop.
Thank you very much.
Aoyama Branch Amamoto




