
[Ferragamo] Bit Loafer – Bit Replacement, Metal Fitting Replacement
[Ferragamo] Bit Loafer – Bit Replacement, Metal Fitting Replacement
3 November 2024
- CATEGORY
- Repair materials
- FERRAGAMO
Bit Loafer.

It’s a hugely popular design, but what exactly is a ‘bit’ in the first place?
A bit is a rod-shaped piece of metal that is placed in a horse’s mouth whilst riding.
It has loops at both ends and is used by attaching it to the reins.
I’d seen horses with them in their mouths before, but as I’d never seen one when it wasn’t in use, I decided to look into it.
I’m told they come in various shapes, but they look rather like a larger version of the metal buckle on a bit loafer.
Those bit loafers,
We occasionally receive comments from customers saying that the bit—which also serves as a design symbol—has broken.
This post is also about a Bit repair.
The bit loafers shown in the photograph above.
Actually, the metal fitting on my left leg has snapped.

As welding and the like are rather difficult, we will replace the part with a new one.
First, we’ll remove this metal tab (the part connecting the metal to the upper).
As it looks as though it can be reused, I shall proceed with the work carefully.

I measured the lengths of the bits I’d removed, and it looked as though the following two would be suitable.
The bit at the back is just the right length, and the design is quite similar.
The one in the foreground is slightly longer than the original, and the design is different too.
From what I’ve heard, you’d probably think it’s all down to the most significant bit.
However, the client has a high instep and says that when wearing these shoes, the metal parts feel constricting and cause pain.
He said he doesn’t mind the change in design.
Following the consultation, we have decided to use the bit at the front this time.
Before replacing it, I’ll try fitting the new part loosely to see how it fits.
It doesn’t seem to be a problem at all; in fact, it might even be a good thing.
As this part is longer than the original, it gives you more room across the instep, and
As the centre section is movable, it helps to alleviate any feeling of confinement, doesn’t it?
Normally, we do not tend to swap bits of different lengths.
If it’s too short, the instep feels tight; if it’s too long, the bit moves around and looks awkward.
However, given the circumstances this time, and as it seemed to be fine after I fitted it temporarily to check, I’ll be using one of a different length.
Right then, let’s sew the new bit onto the main body of the shoe.
I make a point of ensuring that I sew it securely in the original hole and at the original position.

This is what it looks like when both legs have been replaced.

It’s turned out really naturally, hasn’t it?
This has given the instep a bit more room, making them much easier to put on!
Please do feel free to contact us regarding the replacement of bits.
We look forward to welcoming you.
Thank you very much for staying with us until the end.
Yamada

