[ALDEN] Tassel – Lace Reinforcement

[ALDEN] Tassel – Lace Reinforcement

14 October 2022

Today, I’d like to share a few examples of repairs we’ve carried out on tasselled loafers.

 

Here is what you brought with you

 

A pair of Alden tassel loafers.

As it is one of the classic models, I imagine quite a few of you own one.

 

In the wide-angle shot, you might not notice it at first glance, but if you take a closer look…

 

Do you understand?

I’ll move a bit closer

 

 

Perhaps it got caught on something; the cord attached to the tassel has snapped.

Depending on the condition of the cord, we may sometimes extend the broken end with a piece of leather, but

As the original cord was still in good condition, I decided to reuse it this time.

 

 

As I cannot carry out the work whilst the tassel is still attached,

 

 

First, remove the tassel and untie the cord,

 

 

Place the reinforcing material and a thin piece of leather on the reverse side, then join the laces.

It was cut so neatly that the join isn’t noticeable.

 

 

Next, stitch the lined leather and the cord in place, then trim off any excess, and

 

 

The reinforcement of the cord is now complete.

Finally, thread it through the original hole, tie a knot, and attach the tassel, and

 

 

Repair complete!

 

 

If you look at it up close, you can tell it’s been repaired, but

 

 

Looking at the bigger picture,

 

 

I don’t think it will bother you.

 

As it is supported by a thin cord, the structure inevitably ends up bearing too much load.

We can’t quite restore it to its original condition, but we’ll finish it in a way that feels as natural as possible, given its current state.

 

Please do feel free to contact us.

 

Thank you very much.

Yokohama Branch, Shin